FLOOR-PRO 104 AQUA EPOXY PRIMER

FLOOR-PRO 104 AQUA EPOXY PRIMER is a two-component water-based modified amine cured epoxy primer. It is designed to penetrate and seal porous surfaces in concrete. It also provides good adhesion for subsequent topcoat. It is suitable for use as a tie coat between concrete substrate and water-based topcoat

Features

- Excellent adhesion on concrete surfaces
- Fast drying at ambient temperature
- Easy to apply
- Environmentally friendly
- Water-based
- Non-toxic, does not contain lead, mercury and heavy metals

Application Areas

- Ideal as a primer coat, barrier coat or tie coat between any single-pack coatings, two-pack water-based topcoats.
- For application on concrete floor and wall at food factories, laboratories, institutions and interior of buildings.

Application Methods: Applying FLOOR-PRO 104 AQUA EPOXY PRIMER
- Add all the Part A into Part B and mix both liquid parts thoroughly for 2-5 minutes until homogeneous. Transfer the mixed material to a clean container and mix for another minute.
Avoid inclusion of air during the mixing process. May be applied by brush, roller or spray. Spread with a squeegee and back roll with a roller

Overcoating of FLOOR-PRO 104 AQUA EPOXY PRIMER
- Overcoating the previous coat should be done within 3 days but preferably as soon as possible after it has been allowed for minimum of 16 hours drying. Exposure of the paint film to water, chemical and abrasion should be avoided as far as possible before full cure of the coating.

Recommended Painting System
The following Topcoat is recommended for NIPPON FLOOR-PRO 104 AQUA EPOXY PRIMER:
NIPPON FLOOR-PRO 302 AQUA EPOXY FINISH
For the choice of coating system for different application, refer to the product brochure or contact Nippon Paint for professional recommendation.